File Sampler: Split up part files into
smaller pieces
Overview...Split up part files
that are too big for your ShopBot table, or "sample" small sections of larger
texture files to create seemingly random textures or a series of matched panels
with a continuous texture spanning them.
Notes... This will only work with files that contain M and J commands
and NOT files that contain circle commands like CG...they will just pass
through.
Contact info...Bill
Young
Download size...16k
Project Type...Part File Utility
Additional equipment/software required...None
Special instructions...Download the zip file from the link below and
unzip it. You can put this file anywhere that you want...it doesn't need any
other files
Known Issues...None, but as usual double-check the output files just in case.
Confidence...
Completeness...
Download the File Sampler 001
Confidence is a measure of how far along a project
is in the opinion of the person that created it. If it only has 1 star then it's
very rough, more likely to not work than to work correctly. 4 stars means that
they think it's ready for prime time and just needs a little more feedback or
testing. A 5 means that it's all done...you won't see any "5 star" projects in
ShopBot Labs because at that point it's ready for release!
Completeness really goes hand in hand with Confidence and is the
measure of how complete they feel the Project download is. It could include
important things like if there are instructions or help files available, but
also might reflect if there are sample files or even simple things like a lack
of icons or graphics.